Gardner Bender Guide to Profitable Bending - Manual (Page 8)

49
7. Lower the bender handle and complete the bend by pushing down
until the handle stops moving. See Figure 4. Raise the handle and
remove the conduit. See Figure 5.
Figure 4
Figure 5
Figure 3
90° Stub-up and Kick Bend
Instructions for Mini-Eegor ™ ,
Eegor ™ and Ultra Eegor ™
Benders
To Make Either a Stub-up or Kick Bend:
1. Determine “H” dimension by measuring rise or height needed. From
“Diagonal Distance Chart” (page 9 ), determine straight length of
pipe (D) needed to reach to desired turn-up height (H) at desired
bend angle.
2. Measure this distance (D) from end of conduit, and make first mark.
3. From “Set-back Chart”, select proper set-back dimension (S)
corresponding to conduit size and bend angle desired.
4. Measure distance (S) back from first mark, and make second mark
(see figure above).
5. Place conduit in bender with second mark aligned with leading edge
of U-strap (see figure above), and bend conduit to desired angle.
8
E-507 Guide to Profitable Bending rA.qxd 10/19/09 3:17 PM Page 15