Burkert Type 8030 - Manual (Page 8)

8
Wiring
type se30 ex
8 WIrInG
danger
Risk of injury due to electrical discharge
▶ Always insert a female connector and tighten the screw of the
connector.
To make sure the device is tight, always insert a wired
female connector.
The electrical connection of the flowmeter SE30Ex is made via a
4-pin male fixed connector.
1 2
3
4
1: V+ (12-36 V DC)
2: NPN transistor output
3: L- ( 0 V DC)
4: PNP transistor output
Fig. 6: Pin assignment of the male fixed connector
A female connector type 2513 moulded on cable is available as an
accessory to wire the device. See chap. "9 Accessories".
Pin of the female connector type
2513 available as an accessory
Colour of the wire (signal)
1 white (12-36 V DC)
2 brown (NPN transistor output)
3 green (0 V DC)
4 yellow (PNP transistor output)
GND
V+ (12-36 V)
PE
white
brown
green black
Fig. 7: NPN connection of the device with a female connector type 2513
available as an accessory
English