Burkert Type 8030 - Manual (Page 4)

4
Basic safety information
type se30 ex
3 bAsIc sAfety InformAtIon
Apart from the basic safety information described in the operating
instructions of the flowmeter type 8030, respect the following
instructions.
Risk of explosion caused by an accumulation of electrostatic
charges
▶ Check that the device is not subject to a flow of air and dust
that may result in an accumulation of electrostatic charges when
it is installed in zone 22.
▶ Install the device in a conductive cover when it is used in
zone 2.
Danger caused by an explosive atmosphere
▶ Do not dismantle or uninstall the SE30 Ex Hall effect flowmeter
when it is operating.
The standard EC design-examination certificate 04 ATEX
3015 X is available on the Internet at:
www.burkert.com
4 GenerAl InformAtIon
4.1 contact
To contact the manufacturer of the device, use following address:
Bürkert SAS
Rue du Giessen
BP 21
F-67220 TRIEMBACH-AU-VAL
4.2 Warranty conditions
The condition governing the legal warranty is the conforming use of
the device in observance of the operating conditions specified in this
manual.
4.3 certification
The standard EC design-examination certificate 04 ATEX 3015X
and its annexes 04 ATEX 3015 X/01 and 04 ATEX 3015 X/02 have
been drawn up by the following body:
INERIS
Parc technologique Alata
BP 2
F-60550 VERNEUIL EN HALATTE
English