Alpine KTX-100EQ - Manual (Page 9)

7
-EN
ALPINE KTX-100EQ 68-08564Z99-A (EN)
Message List
Message ID Error Message
Error Code: E001 “MultEQ Error: The channel has been marked as undetected, and will be
skipped.”
Error Code: E002 “MultEQ Error: The bass management configuration selected is not
supported by the device. Please consult the manufacturer’s manual to
determine a valid configuration.”
Error Code: E003 “MultEQ Error: The speaker configuration specified is not valid. Please
consult the manufacturer’s manual to determine a valid configuration.”
Error Code: E004 “MultEQ Error: Communication with the device failed. Please check the
connection and try again.”
Error Code: E005 “MultEQ Error: The device is not properly licensed.”
Error Code: E006 “MultEQ Error: Device in use, try again in a few moments.”
Error Code: E007 “MultEQ Error: The Maximum level was reached, without achieving an
adequate signal. Please decrease the ambient noise and try again.”
Error Code: E008 “MultEQ Error: The hardware sample format or bit depth is not supported.”
Error Code: E009 “MultEQ Error: The action was cancelled by the user.”
Error Code: E010 “MultEQ Error: The system was unable to calculate a filter for this response.
Please try your measurements again. If this problem persists, contact
technical support.”
Error Code: E011 “MultEQ Error: The system was unable to determine the delay (speaker to
microphone distance). Measure this value manually.”
Error Code: E012 “MultEQ Error: The system may have been unable to determine the delay
(speaker distance). Numbers given for this value should be checked
manually.”
Error Code: E013 “MultEQ Error: The input signal is too low. Check that the microphone is
connected to the selected input, and check that the gain on the preamp or
audio hardware input channel is properly set.”
Error Code: E014 “MultEQ Error: The measured signal was too low, even though output was
raised to the maximum available amplitude. Decrease ambient noise, and
start over.”
Error Code: E015 “MultEQ Error: The measured background noise exceeded allowable
tolerances.”
Error Code: E016 “MultEQ Error: An unspecified error has occurred.”
Error Code: -1 MEASURE CANCEL
Error Code: -2 MEASURE COMMAND ERROR
Error Code: -3 FL SPERKER NO DETECT
Error Code: -4 H.U NOISE MEASURE START ERROR
Error Code: -5 H.U MEASURE START ERROR
Error Msg: M001 “The MultEQ Pro appliation failed to communicate with the device. Please
check the ALPINE Device configuration and try again.”
Error Msg: M002 “The device is not properly licensed.”
KTX-100EQ.book Page 7 Friday, April 13, 2007 4:31 PM