EXP Computer CRW with CDROM Card - Manual (Page 22)

- 16 -
SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1
Automatic Installation
Follow the instructions below to proceed with automatic installation.
1. Insert the device driver diskette into a floppy disk drive on your computer.
2. Change the working directory to the floppy drive containing the device driver diskette by typing A:
then press ENTER.
3. At the DOS prompt (A:\>), type INSTALL followed by the ENTER key.
4. Press ENTER or click OK button to continue. The screen will display as the following:
1) Directory to install driver: Type the
directory that you want the driver files
are copied to, and then press the TAB
key to forward to the next field.
2) DOS directory: To specify the
directory containing the file
MSCDEX.EXE. Type the directory,
then press the TAB key to forward to the next field.
3) Set I/O port to: The default setting is (170-177, 376-377). Set to (168-16F, 36E-36F) is
recommended. Press the TAB key to forward to the next field.
4) Set IRQ to: The default setting is 15. Set to 9, 10, or 11 is recommended.
5. After completing the selection, press TAB key to the Install button, and press ENTER to continue.