EXP Computer Data Traveler 336E - Manual (Page 6)

2
INSTALLATION
This section contains information that you need to install a ThinFax 336E for
the WINDOWS CE H/PC, including how to insert and remove the card and how to test
the modem's installation with Terminal program.
Note1: To prolong the WINDOWS CE H/PC 's battery life, the following
procedure should be observed:
If possible, use an AC Adapter whenever the ThinFax modem card is
plugged into the WINDOWS CE H/PC.
Use the external battery pack, if you plan to use the card for extended
period while on the H/PC’s battery power.
SYSTEM REQUIREMENTS
Most of the Windows CE H/PC have a limited current supply to the PC Card slot. This
limitation may vary among different manufacturers. Thus, we recommend using the
ThinFax card with the external battery pack attached.
Hardware Installation
Note: Do not insert or remove the PCMCIA card when the WINDOWS CE H/PC
power is on. The illustration shows a typical PC Card slot location. Check
your H/PC users manual for more detail.
Inserting the Card
Hold the card with the EXP logo on the top. Slide the card into the slot located at a side
of the WINDOWS CE H/PC. (See Figure 2)
Figure 2 PC Card slot location
Removing the Card
Close all applications that have open file on the card. Turn off the HPC. Push the eject
button which is usually located on one side of the PC Card slot.
Connecting the ThinFax 336E parts together
The following figure illustrate how to connect all the ThinFax 336 components
together.
Figure 3 ThinFax Components