Emtek Modern Keypad Leverset Locksets (Adjustable Latch) - Manual (Page 10)

10
In order to perform each of the following six functions, the lock must first be
placed in Programming Mode:
*If no input within 10 seconds, Yellow LED goes out, Red LED flashes and lock exits Programming Mode.
1. Press and hold EMTEK button for 3 seconds
2. Yellow LED flashes, then remains solid*, number keys also illuminate
3. Enter Programming Code
4. Green LED flashes, then 2 beeps
5. Yellow LED remains solid (awaiting button press; see following Table)
I
f you wIsh to
P
ress
B
utton
A
ctIons
I
ndIcAtors
Change
Programming
Code
(6 digits)
1 Enter New
Programming
Code
(6 digits)
Re-Enter
New
Programming
Code
(6 digits)
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
Add User Code
(4 digits)
(Store up to 20
User Codes)
2 Enter New
User Code
(4 digits)
Re-Enter
New User
Code
(4 digits)
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
Delete User Code 3 Enter User
Code to be
Deleted
Re-Enter
User Code to
be Deleted
• 1 Green LED flash
• 1 beep
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
**
Enable/Disable
All User Codes
4 Entering ‘4’ disables all Users
(enables all if disabled)
• 2 Green LED flashes
• 2 beeps
Delete All User
Codes
5 Re-Enter Programming Code • 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
Turn Beeper On/
Off
6 Entering ‘6’ turns OFF (or ON) • 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
**Also referred to as “vacation mode”. This command temporarily disables all user codes (metal key
override will still work).
How to Program
Programming Your Lock