Dynasonics DXN Portable Ultrasonic Measurement System Firmware Update - Manual (Page 13)

This condition requires a hard reboot by pressing and holding the main power button until the unit turns off When
the power button is pressed again the meter should start normally
A successful update is verified by noting the revision letter in the upper right hand corner of the Start screen It
should match the revision letter noted when the updater zip file was extracted
Series DXN
dynasonics.com 800-535-3569 ©2012 Racine Federated Inc., all rights reserved
Launching in 17 seconds
or click here to begin
Start Using Factory Defaults
Start Using Guided Setup Wizard
Rev H
Firmware Update Manual
Page 13 May 2013