Datamax-O'Neil LP3 LABEL PRINTER User Guide - Manual (Page 14)

LP 3 LABEL PRINTER USER'S GUIDE
11
7. Pull the slack from the media and close the label presenter
(Figure 26).
8. Press the Media Function button so that at least one label
presents (Figure 27). The printer separates the linered
media as shown in Figure 28 (side view). The media's
backing should separate from the adhesive (Figure 28) .
If you print more than one label during a print job, the
printer waits for you to remove the label before presenting
the next label.
Figure 26
Label presenter
Edge of media
Figure 28 Figure 27
Media backing
Label presenter
Media (presented)