Datamax-O'Neil I-Class Mark II Operator’s Manual - Manual (Page 13)

Chapter 2 - Printer Setup 7
2 2 2 . . . 3 3 3 M M M e e e d d d i i i a a a S S S e e e n n n s s s o o o r r r A A A d d d j j j u u u s s s t t t m m m e e e n n n t t t
The Media Sensor needs to be positioned so that the printer can detect the presence of media and
the top-of-form (except for continuous stock, where the TOF is set through the front panel).
To adjust:
1. With media loaded, as described in Section 2.2, grasp the Slide Tab and move the Sensor
Eye Mark into position over media according to the table below.
 ‘Sensor Eye’ Mark
 Slide Tab
Media Sensor Selection and Adjustment
Media Type Sensor Eye Mark Position Sensing Required
Die-cut Near the middle of the label Gap
Notched Centered over the notch Notch
Reflective Centered over the black mark Black Mark
Continuous Near the middle of the media Continuous