Datamax-O'Neil I-Class Peel and Present Option User Manual
Page 6
4
Setup and Configuration
The printer will automatically sense the presence of the Present Sensor and allow it to be enabled for
present printing. If you wish to enable the Present Sensor it must be enabled within the menu system. To
‘Enable’ or ‘Disable’ the Present Sensor follow the steps below.
Verify the printer is in the ‘Ready Mode’
Press the button. Using the
button scroll to ‘Printer Options’ and press the
button.
Using the button scroll to ‘Present Sensor’
and press the button.
Using the button scroll to either ‘Enable’ or
‘Disable. Press the button to select the
displayed setting, an asterisk will appear to the
left of the setting indicating that it is selected.
Once you have selected the desired setting
press the button repeatedly until the ‘Save
Changes’ message is displayed. Press the
button to save the changes or the button to
discard the changes.
Note: The use of the present sensor can also be controlled via software commands from the host.
Media Loading
Press in on the Peel Mechanism Latch and
allow the Peel Mechanism Front Cover to
swing open.
Load the printer with media, (see the
Operator’s Manual for more information).
Peel Mechanism
Latch
Peel Mechanism
Front Cover