Datamax-O'Neil H-Class RFID Option User Manual
Page 3
1
This guide presents a systematic overview of important media requirements, setup options, and modes of
use for Datamax-O’Neil H-Class RFID-equipped printers.
CAUTION
•
This device complies with FCC Radio Frequency exposure limits for an uncontrolled
environment. This equipment should be installed and operated with a minimum
distance of 20cm between the radiator and your body. If 20cm distance cannot be
maintained, end users are to be 20cm from printer extremity.
•
Any changes or modifications to this RFID module not expressly approved by
Datamax-O’Neil Corporation will void the user’s authority to operate the equipment.
•
Operation is subject to the following conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of this device.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at their own expense.