Datamax-O'Neil ANDES 3 User Guide - Manual (Page 15)

11
3.2.2 Setting Dip Switches
ON
1 2 3 4 5 6 7 8
FIGURE 12: EXAMPLE: DIP SWITCH #1 SHOWN IN ‘ON’ POSITION
Note: Use care when changing dip switch settings. Carefully use a pointer on the dip switch
you are going to change. DO NOT use a screw driver or apply excessive force.
3.2.3 Dip Switch Functions
Note: (Developer’s refer to Programming Manual for more information)
Table 2 – DIP Switch Setting
Dip Switch Function Switch # Switch # Switch # Notes
1 & 2 Communication Interface SW 1 SW 2
RS232 OFF OFF Baud rate set by Dip switches 3,4 and 5
IrDA ON OFF
Baud Rate can be negotiated up to the value
specified through Dip switches 3,4 and 5
Bluetooth OFF ON
BT Baud Rate set for 57600 bps.
Dip switches 3,4 and 5 must be set to OFF
position
802.11b ON ON
802.11 Baud Rate set for 57600 bps
Dip switches 3,4 and 5 must be set to OFF
position
3 & 4 & 5 Baud Rate SW 3 SW 4 SW 5
57600 OFF OFF OFF
38400 OFF ON OFF
19200 ON ON OFF
14400 OFF OFF ON
9600 ON OFF ON Use for fixed IrDA
2400 OFF ON ON
1200 ON ON ON
6 Parity Bit SW 6
Parity Enabled ON Does not apply for IrDA
Parity Disabled OFF Does not apply for IrDA
7 Odd/Even SW 7
Even Parity Checker ON Does not apply for IrDA
Odd Parity Checker OFF Does not apply for IrDA
8 Auto Power Save SW 8
Power Save Disabled OFF Manual On/Off
Power Save Enabled ON Auto Power Down
Note: In order for changes to the dip switch configuration to take effect, the printer power
must be reset. This action occurs automatically when the battery is removed to gain access
to the dip switches.