Overview, Contents of the kit, Firmware update required – Datamax-O'Neil DMXNetII User Manual
Page 3
O v e r v i e w
1
Overview
This document describes the installation and use of the DMXrfNetII and DMXNetII Card options for the H-Class, I-Class,
and A-Class printers. After verifying the contents of the kit and the tools needed, follow the steps below to install and
begin using the option. Keep this documentation for future reference.
CAUTION
For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the printer’s
power cord before beginning this installation.
Contents of the Kit
Note:
If your card is already installed proceed to “Card Setup and Operation”
This kit contains the following items:
• Network Card Assembly
• Rear Cover Plate
• Screws
(Appearance may vary depending on card configuration.)
Firmware Update Required
If you are installing this card into an existing printer, you must upgrade the printers firmware to support this network card.
Updated firmware can be downloaded from the Datamax-O’Neil FTP site at ftp.datamax-oneil.com. Refer to the printers
operator’s manual for more information on updating the printers firmware. Be sure the firmware file that you download is
version 11.04 or greater. Before installing new firmware verify (via a Configuration Label) that the printer bootloader is
version 11.01 or greater.