Analog Way NeXtage 16 User Manual
Page 2
Analog Way Worldwide
Europe, Middle East & Africa: +33 (0)1 81 89 08 60
The Americas: +1 212 269 1902
Asia Pacific: +65 6292 5800
www.analogway.com
CAUTION!
Make sure to provide an adequate ventilation for the device. When you install it into
the rack, make sure no ventilation holes are blocked. The air intakes by the front panel
and exhausts by the back of the unit.
Make sure that the rails will pass through the back ears by the minimum of 15mm/
0,59 inch
To install the rear rack rail:
Once your unit is installed into your rack, please use 4 M4x10 screws to put the rear rail on each side of the
device. You will find on each side 4 holes where the screws can be put into.
To screw the rail to the rack, you need 2 screws on each side, those screws are not included into the package.
A lacing bar is available in the rail mount pack. Install this bar anywhere between the two rails using 2 M4x10
screws. Choose the right distance according to your cable position. Then you can use tie cables to maintain
your video cables on this lacing bar.