Manta g-032b/c, Chapter – ALLIED Vision Technologies Manta G-917 User Manual
Page 26
Manta Technical Manual V7.0.1
26
Specifications
Manta G-032B/C
Feature
Specification
Sensor
Type 1/3 (diag. 6 mm) progressive scan SONY IT CCD ICX424AL/AQ with HAD
microlens
Effective chip size
4.9 mm x 3.6 mm
Cell size
7.4 μm x 7.4 μm
Resolution (maximum)
656 x 492 pixels
Lens mount
C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 9.7 mm (see
CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 5.1 mm (see
ADC
12 bit
Pixel format
Only monochrome: Mono8, Mono12Packed, Mono12
Only color: BayerRG8, BayerRG12Packed, BayerGR12, Mono8, RGB8Packed,
YUV411Packed, YUV422Packet, YUV444Packed, BGR8Packed, RGBA8Packed,
BGRA8Packed
Frame rates
Up to 80 fps
Gain control
Manual: 0–36 dB (1 dB/step); auto gain (select. ROI)
Exposure time
26 μs to 60 s; auto shutter (select. ROI)
External trigger event
Rising edge, falling edge, any edge, level high, level low
External trigger delay
0 to 60 seconds in 1 μs increments
Fixed rate control
0.01 fps to maximum frame rate (steps of 0.1 fps)
Imaging modes
Free-running, external trigger, fixed rate, software trigger
Sync Out modes
Trigger ready, trigger input, exposing, readout, imaging, strobe, GPO
Internal image memory
32 MByte, up to 99 frames
Smart functions
Auto gain control, auto exposure control,
32 MByte image memory, binning
(monochrome binning, also for color cameras; but no color binning), no
decimation (no sub-sampling), config files (user sets), LUT
only color: auto white balance, color correction, edge filter (sharpness), hue,
saturation
I/O
Two configurable optocoupled inputs, two configurable optocoupled outputs
RS232 port (serial port)
Digital interface
IEEE 802.3 1000BASE-T (GigE Vision V1.2)
Camera control interface GenICam V1.0 compliant
Table 4: Specification Manta G-032B/C
Note
The number of frames (StreamHoldCapacity) depends on resolu-
tion and pixel format. Listed number of frames is typical for full
resolution and Mono8/Bayer8.