ALLIED Vision Technologies Manta G-917 - Manual (Page 24)

Manta Technical Manual V7.0.1
24
Specifications
Specifications
Manta G-031B/C
Caution

Before operating any AVT camera, read the safety instructions
and ESD warnings in the AVT GigE Installation Manual.
http://www.alliedvisiontec.com/emea/support/downloads/
product-literature/manta.html
Note

PoE capable cameras
How can I distinguish between PoE capable cameras and
cameras that are not PoE capable?
PoE capable cameras have the letters PoE written on the
camera’s label on the bottom side of the camera.
Feature Specification
Sensor Type 1/4 (diag. 4.5 mm) progressive scan SONY IT CCD ICX618AL/AQ with
EXview HAD CCD II microlens
Effective chip size 3.6 mm x 2.7 mm
Cell size 5.6 μm x 5.6 μm
Resolution (maximum) 656 x 492 pixels
Lens mount C-Mount: 17.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 9.7 mm (see
figure 48 on page 86)
CS-Mount: 12.526 mm (in air); Ø 25.4 mm (32 tpi)
Maximum protrusion: 5.1 mm (see
figure 49 on page 87)
ADC 14 bit
Pixel format Only monochrome: Mono8, Mono12Packed, Mono12
Only color: BayerRG8, BayerRG12Packed, BayerGR12, Mono8,
RGB8Packed, YUV411Packed, YUV422Packet, YUV444Packed,
BGR8Packed, RGBA8Packed, BGRA8Packed
Frame rates Up to 125 fps
Gain control Manual: 0–32 dB (1 dB/step); auto gain (select. ROI)
Exposure time 58 μs to 60 s; auto shutter (select. ROI)
External trigger event Rising edge, falling edge, any edge, level high, level low
External trigger delay 0 to 40 seconds in 1 μs increments
Fixed rate control 0.01 fps to maximum frame rate (steps of 0.1 fps)
Imaging modes Free-running, external trigger, fixed rate, software trigger
Table 3: Specification Manta G-031B/C