CHIEF K-Series - Manual (Page 6)

Model: K-Series Installation Instructions
6
INSTALLATION TO DESK
Two installation options exist:
• Edge Installation
• Hole (Grommet) Installation; requires 3/8" to 3"
diameter hole and access to the bottom of the
desk
ASSEMBLY
1. Verify that you have the following parts:
2. Determine approximate location for mount keeping in
mind display size, extension, height adjustment (if
applicable), and pitch/roll requirements.
3. Peel backing from adhesive bumpers (40) and attach
to bottom of mount (10) (See Figure 4).
NOTE: One extra bumper (40) included for convenience.
Figure 4: Install Bumpers
EDGE INSTALLATION
IMPORTANT ! : IF you will be installing a SINGLE
display (including KCY-210/-220) with RECESSED
mounting holes, then proceed to "DISPLAY
INSTALLATION" before continuing with this mount
installation procedure.
NOTE: Bracket (20) and screw (30) are not used in this
installation.
1. Slip mount (10) over edge of desk so that clamp fully
contacts desk edge. Using 3/16" hex key, securely
tighten clamp adjustment screw (See Figure 5).
Figure 5: Desk Mount - Edge Installation
2. If you are installing:
• SINGLE display with RECESSED mounting
holes: Proceed to "CABLE MANAGEMENT."
• KCY-210/-220: Proceed to "MULTI-DUAL ARM
ASSEMBLY."
• ALL other display configurations: Proceed to
"DISPLAY INSTALLATION."
HOLE (GROMMET) INSTALLATION
1. Using 2.5mm hex key, remove and retain baseplate
and three attach screws from bottom of mount (10)
(See Figure 6).
Figure 6: Baseplate
2. Using 3/16" hex key, remove clamp adjustment
screw, washer, and clamp (See Figure 7). Retain
clamp adjustment screw and washer for later use.
NOTE: Clamp will not be used for Hole (Grommet)
Installation.
Item Description Qty
10 MOUNT, Desk, K-Series 1
20 BRACKET, Grommet 1
30 SCREW, Button Head Cap, 5/16"-18 x 4" 1
40 BUMPER, Adhesive 6
10
40
(5 places)
10
Clamp Adjustment
Screw
Edge
Clamp
of Desk
Baseplate
Attach Screws
(3 places)
10
Baseplate
Nut