CHIEF K-Series - Manual (Page 3)

Model: K-Series Installation Instructions
3
CONTENTS
TOOLS REQUIRED FOR INSTALLATION ............................................................................................................... 3
SPECIFICATIONS .....................................................................................................................................................4
MOUNT INSTALLATION ........................................................................................................................................... 5
DISPLAY INSTALLATION .........................................................................................................................................8
ARRAY ASSEMBLY (DUAL / TRIPLE DISPLAY; ALL EXCEPT KCY-210/-220)..................................................... 10
MULTI-DUAL ARM ASSEMBLY (KCY-210/-220 ONLY).......................................................................................... 11
CABLE MANAGEMENT .......................................................................................................................................... 12
ADJUSTMENT ........................................................................................................................................................ 13
TOOLS REQUIRED FOR INSTALLATION
• Phillips Screwdriver, #1 and #2
• 9/16" Wrench (KSA-1015/-1016 Only)
• Drill (All Wall Mounts)
• 1/8" Drill Bit (All Wall Mounts except KSA-1015/-1016)
• 1/4" Drill Bit (KSA-1015/-1016 Only)
• 2.5mm Hex Key (approximately 3/32"; provided with Desk Mounts)
• 5/32" Hex Key (provided with applicable K-Series mounts)
• 3/16" Hex Key (provided with all K-Series mounts)
NOTE: Other tools may be required depending on your method of installation.