CHIEF K-Series - Manual (Page 14)

Model: K-Series Installation Instructions
14
HEIGHT ADJUSTABLE (IF APPLICABLE)
IMPORTANT ! : It is important that the mount be
attached to the mounting surface AND display be
attached to the mount BEFORE attempting to adjust the
height adjustable arm.
1. Using 5/32" hex key, slightly loosen or tighten the
adjustment screw as necessary (See Figure 25).
• If display settles on its own, then rotate
adjustment screw counterclockwise (towards the
"+" symbol).
• If display rises on its own, then rotate adjustment
screw clockwise (towards the "-" symbol).
NOTE: It may be necessary to raise or lower the height
adjustable arm to expose the adjustment screw.
Figure 25: Height Adjustable Arm Adjustment
CENTRIS HEAD
SINGLE DISPLAY AND KCY-210/-220
1. If previously attached, disconnect cables from display,
then remove display.
2. Using Phillips screwdriver, slightly loosen or tighten
the adjustment screw as necessary (See Figure 26).
Figure 26: Single Display Adjustment
3. Install mount and then display cables. See "DISPLAY
INSTALLATION."
DUAL / TRIPLE DISPLAY
1. LATERAL POSITION ON ARRAY:
• Using your fingers, slightly loosen adjustment
knob "A" (See Figure 27).
• Slide display to desired position.
• Using your fingers, tighten adjustment knob "A".
Figure 27: Dual / Triple Display Adjustment
2. PITCH / YAW / ROLL:
• Using your fingers, slightly loosen adjustment
knob "B" (See Figure 27).
• Adjust display as desired.
• Using your fingers, tighten adjustment knob "B".
Adjustment Screw
Adjustment Screw
Phillips Screwdriver
A B