CEMB USA N100 - Manual (Page 61)

Information related to the creation of Templates
D - 1
Appendix D
Information related to the creation of
customised
templates (models) for
certificates generated by CEMB N-Pro
software.
Numeric codes
When the certificate is created, the CEMB N-Pro software automatically replaces some of
the default codes in the template (#x# format) with corresponding information related to
the measurements displayed at the time.
To ensure they are replaced correctly, only the following codes should be used:
#1# Current date
#2# Current time
#3# Note number 1 added to the measurement
#4# Image of the spectrum graph for channel A
#5# Image of the spectrum graph for channel B
#6# Name of the measurement
#7# Path of the file containing the measurement
#8# Serial number of the N100 or N300 instrument
#11# Type of measurement (Pk, PP, RMS)
#12# Type of sensor connected to channel A
#13# Type of sensor connected to channel B
#14# Measurement (overall, 1xRPM, 2xRPM, …)
#15# Number of averages (only for overall measurement)
#16#
Synchronous filter width, expressed as a % (only for synchronous
measurements or balancing)
#17# Maximum frequency measured (only for overall measurement)
#18# Number of lines in the spectrum
#19# Note number 2 added to the measurement
#20# Note number 3 added to the measurement
#48#
Model of apparatus used to take the measurement
(N100, N300)