CEMB USA C72_2SE (C) - Manual (Page 14)

I 0391 - 14 I 0391 - 15
13
FI FE
12
11
GB GB
5.4.1 - Exact positioning of the adhesive weight by means of the gauge with clips
In correction mode ALUS it is possible to cancel approximations in the mounting of the counterweights by proceeding
as follows:
- press
- Insert the correction weight into the specific seat on the weight clip with the adhesive part facing upwards
- Remove the gauge when the display shows:
to indicate that the gauge should be pulled further out
to indicate that the gauge should be returned to rest position
The left display gives the indications for reaching the position regarding the inside, while the right display that of the
outside. The position of the gauge is also indicated by the position repeater Led (8).
Position
reached on
the internal side
- Bring the wheel into correct angular position
- Move the gauge until the display corresponding to the selected correction plane shows the unbalance
- Rotate the rim until the correct weight lies against the rim.
- The fact that the weight application position is no longer vertical (fig. 13) is offset automatically (where appropriate
use the weight pusher).
N.B. : It is not possible to put automatically the correction weight in the Fig.8/Pos.B position; always
rotate the rim in Fig.8/Pos.A.
Position
reached on
the external side