CEMB USA C75_2-L (A) - Manual (Page 15)

I 0463 - 15
/
/
9
FE FI
GB
5.3.1.3 - Wheels ALUS
After the measurement performed for the FI inner side, as indicated in fig. 9, pull out the gauge again to store the
data for the FE outer side; choose position A or B (fig. 8) at your choice. Keep this position for at least 2 seconds.
The counterweight symbols change colour.
When the acoustic signal is enabled (see
ACOUSTIC SIGNAL ), the acquisition is accompanied by a “beep”.
After having detected the dimensions, use the key to indicate the type of correction selected for the inner side.
The following buttons are enabled:
Management of save user recall
Selection of clip or adhesive weight for inside.
Only for automatic width option:
The L.T. key (LIGHT TRUCK) used to improve the dimensional calibration of large-diameter wheels
such as off-road, trucks, wheels which protrude significantly from the rim. Press the L.T. key, after
distance measurement, immediately before lowering the guard for Width Measurement.
The option is disengaged at the end of current Width Measurement.
Selecting the manual dimension presetting screen
Return to initial screen.
Balancing run.
Position of
adhesive
weights