CEMB USA C88 (A) - Manual (Page 14)

I 0607 - 14
9
FE FI
GB
After having detected the dimensions, use the key to indicate the type of correction selected for the
inner side.
The buttons enabled in the case of: - automatic width measurement
- automatic ALUS wheel measurement
are:
USER CONTROL
only for automatic width:
This button is used to improve the dimensional calibration of large-diameter wheels such as off-
road, trucks, wheels which protrude signifi cantly from the rim. Press this button several times to select
the type of tyre projection (from 1.0” to 2.0”). The option is disengaged at the end of current Width Mea
surement.
selection of clip or adhesive weight for inside.
selecting the manual dimension presetting screen
return to initial screen.
balancing run.
5.3.2 - ALUS wheel automatic presetting
After the measurement performed for the FI inner side, as indicated in fi g. 9, pull out the gauge again to store the
data for the FE outer side; choose position A or B (fi g. 8) at your choice. Keep this position for at least 2 seconds.
When the acoustic signal is enabled (
ACOUSTIC SIGNAL
), the acquisition is accompanied by a “beep”.
►
Position of
adhesive
weights
N.B.: The ALUS dimensions can in any case be set manually using the buttons described in
“ DIMENSIONS ”.