CEMB USA C88 (A) - Manual (Page 12)

I 0607 - 12
Pos B
Pos A
FI
8
8a
GB
5.3 - Presetting wheel dimensions
5.3.1 - Automatic standard wheel setting
►
►
The screen appears upon removing the distance + diameter gauge.
The “dimension acquired” message is indicated by the correction weight symbol, which changes from light blue to
red.
- Standard wheels: Using the special grip, move the end of the gauge against the rim in one of the positions A/B
shown.
a) Sprung weight : in one of the positions A/B indicated in fi gure 8.
L.T. /SUV FUNCTION
ON INDICATOR
(see enabled buttons)
FUNCTION ON
INDICATOR: Sonar
“WIDTH”.
b) Adhesive weight: in the position indicated below.
Note: always use the round part of the striker plate.
Position of adhesive
weight
Hold the gauge in position for at least 2 seconds.
If the acoustic signal is enabled (
ACOUSTIC SIGNAL
), the acquisition of the dimensions is accompanied by a
“beep”.