CEMB USA C212 (A) User Manual
Page 7
I 0648
- 7
b
a
b
GB
5 - USE OF THE WHEEL BALANCER
5.1 - DATA SETTING
►
Press the button
; LED on
→
balancing machine set in car mode
Press the button
; LED on
→
balancing machine set in truck mode
The balancing data is set by means of an "intelligent" automatic gauge; confi rmation of the measurement and the
position appear on the display. The round part of the gauge must rest on the rim where the weight will be positioned.
While the gauge is moving the following appears
;
when the measurement has been stored
.
a) standard weights: When only one measurement is made, the machine interprets the presence of a rim with clip-
on weight correction
The width value (b) must be set with the buttons
. The correct measurement is that which can be
measured with the compass gauge provided.
b) adhesive weights: Make two successive measurements on two correction planes inside the rim.
The balancing machine automatically interprets that the correction will be made with adhesive weights and
the following appears:
For a different combination of the type or position of the weights on the rim, use the button
.