CEMB USA C211 (C) - Manual (Page 11)

I 0147 - 10 I 0147 - 11
12
GB GB
6.3 - Presetting with gauge extension
The extension increases the distance measuring range of the gauge by 10 cm (fig. 12).
Proceed as follows:
- Insert the extension on the distance gauge.
- Measure the distance as already described in the above procedures.
- After reading value “a” on the scale, return the gauge to 0 and preset the value “a + 10” in manual mode.
- Preset the diameter and width in manual mode as illustrated in fig. 10:
unit of measurement = grams unit
of measurement = ounces
N.B.
- Each time the dimensions are changed and a spin is performed subsequently, the system saves Program 1 in Pro-
gram 2 while the current dimensions are saved in Program 1. In this way, the programs regarding the last two types
of wheels balanced are always available.
- This mode of operating is also valid for dimensions regarding the special “ALU-S” function.
6.4 - Double operator program
This program allows memorizes the dimensions of two types of wheels.
Thus two operators can work simultaneously on two different vehicles using the same balancing machine.
The system always memorizes two programs regarding the last two spins carried out with the various preset
dimensions.
When the machine is switched on, the programs are the same.
To change the program, press
Display, Program 1:
DIMENSIONS: as shown in fig. 10a/b/c
UNBALANCE: as shown in fig. 13-14
Display, Program 2:
DIMENSIONS UNBALANCE
extension
reading