J&M GW15t-1 - Manual (Page 18)

GC15
t
-1 G
ravity
W
aGon
a
ssembly
-18-
Finish attaching the shell body to the 16 ton running gear. Use (4) 1/2” x 6” hex bolts, (4) 1/2”
centerlock hex nuts and (16) 1/2” flat washers to fasten the shell to the running gear.
Tighten all of the hardware installed in this step.
Attach the shell body to the 16 ton running gear. Starting in the rear, use (4) 1/2” x 6” hex bolts,
(4) 1/2” centerlock hex nuts, (8) 1/2” flat washers, a 7/8” x 8” hex bolt, (2) 7/8” flat washers, and
a 7/8” centerlock hex nut to join the shell body and running gear. Tighten all of the hardware in-
stalled in this step. Only tighten the 7/8” centerlock hex nut an 1/8” past the end of the bolt.
STEP - 32
STEP - 33
These washers
are used as shims.