J&M GW15t-1 User Manual
Page 14
GC15
t
-1 G
ravity
W
aGon
a
ssembly
-14-
Begin to assemble the 16 Ton Running Gear. Start by sliding the Coupling Pole Weldment through
the Rear Axle and the Retaining Ring. Use a 1” x 6-1/2” Hex Bolt and a 1” Centerlock Hex Nut to
attach the Retaining Ring and Coupling Pole Weldment to the Rear Axle.
STEP - 26
STEP - 25
Install the Wire Wrap Bar. Use (2) 1/4”-20 x 3/4” self tapping screws to install the bar. Self tap your
first screw at the labeled dimension. Do not tighten the screw all of the way. Now level the wire-
wrap bar to the ground. Install the last screw. Completely tighten both self tapping screws.
See also other documents in the category J&M Gardening equipment:
- 525-14W (31 pages)
- 750-16 (33 pages)
- 750-18 (34 pages)
- 1000-20 (31 pages)
- 1050-20 (37 pages)
- 1130-20 (36 pages)
- 1325-20 (36 pages)
- GC-24T Manual (39 pages)
- GC-31T Manual (38 pages)
- GRAIN CARTS Leaner Setup (18 pages)
- 250-7S (12 pages)
- 385SD (13 pages)
- 440SD (13 pages)
- 680SD (13 pages)
- 750SD (13 pages)
- 275ST (62 pages)
- 375ST (62 pages)
- 500ST (51 pages)
- 375ST Remote (24 pages)
- 500ST Remote (23 pages)
- PRO 450 (31 pages)
- TF2 (37 pages)
- HT-974 (16 pages)
- TB-3500-6000A (20 pages)
- TB-3500-6000H (21 pages)
- TB-8000H-42 (20 pages)
- 4WS15 (27 pages)
- 750-14 (29 pages)
- 818 (35 pages)
- 875-16 (29 pages)
- 1000-20S (34 pages)
- 1050-18S (28 pages)
- 1050-18D (22 pages)
- 1050-20S (33 pages)
- 1050-20D (33 pages)
- 1050-22S (23 pages)
- 1050-22D (14 pages)
- 1051-22S (33 pages)
- 1051-22D (33 pages)
- 1075-18R (23 pages)
- 1075-22R (23 pages)
- 1325-20S (33 pages)
- 1325-20D (33 pages)
- 1325-22S (23 pages)