J&M GW15t-1 - Manual (Page 12)

GC15
t
-1 G
ravity
W
aGon
a
ssembly
-12-
STEP - 21
Install the Chute. Use (2) zinc plated snap rings, and (2) 1/2” x 2-1/8” flat washers, to mount the
Chute to the Chute Guides.
STEP - 22
Install the Center-dump Chute. Use (2) 3/8-16 x 1-1/2” hex bolts and (2) 3/8”-16 hex nuts to attach
the Chute to the shell. Slide the bolt through the chute, then turn the nut on to the bolt. Once the
bolt is on, turn the bolt into the tapped hole which is located on the tab welded to the shell. Tighten
the bolt and nut once finished.
O
PTI
O
N
AL