J&M GW15t-1 - Manual (Page 11)

GC15
t
-1 G
ravity
W
aGon
a
ssembly
-11-
STEP - 20
Install the Rack Track Assembly. Slide the Track up through the opening in the door, then turn the
Rack once the Track meets the gears on the Rack. Use (2) 8.8 M10 x 25 MM serrated flange hex
head bolts and (2) M10 serrated flange hex head nuts to attach the Rack Track to the slide gate.
Once the Rack Track is assembled tighten all hardware on the gravity wagon.
Install the Chute Guides. Use (4) 8.8 M10 x 25 MM serrated flange hex head bolts and (4) M10
serrated flange hex head nuts to attach the Rack to the shell body. Place (3) washers in-between
the chute and shell per bolt for the top hole on each chute. Place (2) washers in-between the chute
and shell per bolt for the bottom hole on each chute.
STEP - 19