Neff K8111X0 - Manual (Page 28)

en
28
Proceed as follows:
1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse!
3. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid.
The rinsing water must not run into
the light.
Rinsing water must not run through
the drainage hole into the evaporation
area.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. After cleaning reconnect and switch
the appliance back on.
Notes
■ Regularly clean the condensation
channels and drainage hole, Fig. *,
with a cotton bud or similar implement
to ensure that the condensation can
drain.
■ After cleaning, the stopper must be re-
inserted into the drainage hole of the
refrigerator compartment for functional
reasons.
Interior fittings
All variable parts of the appliance can be
taken out for cleaning.
Taking out the glass shelf “EasyLift”
Fig.
5
Move glass shelf all the way upwards
and take out.
Taking out the door shelf “EasyLift”
Fig.
6
Move door shelf all the way upwards and
take out.
Taking out the fixed glass shelf
Fig.
7
Press buttons on the underside and
detach from the fixing.
Removing the container
Fig.
+
Tilt container forwards and take out.
To insert the container, place the front of
the container on the telescopic rails and
push into the appliance. The container is
engaged by pushing it into the appliance.
Remove telescopic rails
Fig.
,
1. Pull out the telescopic rail.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear
pin.
4. Push telescopic rail together, push
backwards above the rear pin and
disengage.
Installing telescopic rails
1. Place the extended telescopic rail on
the front pin.
2. Pull the telescopic rail forwards
slightly until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards.