Q.V.P. Es10 - Automatic Veneering - Manual (Page 2)

Quality VAKuum Products, Inc.
Or visit our site at
www.qualityvak.com CALL 1-800-547-5484 TODAY!
4. When at sea level the VAKuum Sensor is set to turn off at 24" Hg. and on again at
approximately 20" Hg. Turn the screw counterclockwise to reduce the turn-off point if so desired.
This will be necessary if you live at higher elevations. You lose about 1" Hg for every 1000' above
sea level. If you want the maximum pressing force, and elevation is not a problem, then do not
touch the vacuum sensor screw. Remember, if you turn the sensor down to shut off below 20" Hg,
then the vacuum level will drop more than the original 4" Hg before the system turns back on. This
drop might be as large as 7" to 9" Hg.
5. ON/OFF Switch. This is a 3 position rocker switch. When set to "VAK BAG" the unit will
automatically regulate the correct vacuum level within the bag. The "VAK KLAMP" setting will run
your pump continuously.
6. Vacuum Tank. Less cycling on and off will occur if you add a vacuum tank to your system.
Place it in the line between the Tee and the bag. If the bag rips or leaks for any reason, the pump
will cycle on and off excessively and the tank will reduce the cycling. Unlike the air-powered VAK
Pumps, excessive on/off cycles will damage the electric vacuum pump and void the
manufacturers warranty. Excessive cycling of the pump will also cause it to over heat and shut off,
possible causing the loss of your work.
WARNING, NEVER RUN THE PUMP IN THE “VAK BAG” MODE WHEN VAKUUM KLAMPING. FOR
SAFETY REASONS, THE PUMP MUST ALWAYS RUN CONTINUOUSLY WHEN VAKUUM
KLAMPING; THEREFORE, KEEP IT IN THE "VAK KLAMP" POSITION TO RUN THE PUMP
CONTINUOUSLY.
Please take the time to read the operators manual that is supplied by the pump manufacturer
Maintance is required..
Conditions of sale
WARRANTIES AND DISCLAIMERS. SELLER MAKES NO WARRANTY, EXPRESSED OR IMPLIED,
CONCERNING THE PRODUCT OR MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except;
(a) that the product shall conform to the description contained herein and to the specifications, if
any, attached hereto; and (b) that the product does not infringe on any valid United States
patent. Seller does not warrant, however, that the use of the product, or articles made therefrom,
either alone or in conjunction with other material, will not infringe any United States Patent.
Liability Limitations. Buyer's exclusive remedy shall be for damages and no claim of any kind,
whether as to product delivery or for non delivery of product, and whether based on contract,
breach of warranty, negligence or otherwise, shall be greater in amount than the purchase price
of the quantity of product in respect of which damages are claimed. In no event shall Seller be
liable for incidental or consequential damages, whether Buyer's claim is based on contract,
breach of warranty, negligence or otherwise.
June 26, 2012
ES5 or ES10 AUTOMATIC SET-UP DIAGRAM
AUTOMATIC VAKUUM BAG OR FRAME PRESS VENEERING
6/5/08 - ES5 Automatic VB&FP Veneering.cdr
74 Apsley St. - Hudson, MA 01749
Tel: 978-562-4680 - Fax: 978-562-4681