DE-STA-CO P1700 - Manual (Page 5)

3
SECTION 1: General Information (continued)
1.2.4. Reducers should be of minimum backlash variety and directly coupled with a
backlash-free connection. If line shafts are used, they must be sized for severe
reversing loads.
1.2.5. When using chain or belt drives, incorporate an idler to eliminate any slack. (Do
not use spring-loaded idlers.) As the cam motion stops and starts, any slack in
the drive changes sides. It is necessary to maintain a constant speed of the input
shaft. Loose V-belts or chains will cause inertial over-run, causing distorted
acceleration and deceleration characteristics which may cause damage to the unit.
Belts and chains must be sized for severe reversing loads.
1.2.6. Ferguson does not provide guarding for other moving parts, such as pulleys,
handwheels, switch cams, etc. Numerous pinch points do exist on this equipment
and the possibility exists of being struck by a moving part. Since this product is
expected to become part of a further developed machine, it is the customer’s
responsibility to add safety fencing, guarding, light curtains or other protection
devices, as necessary, to protect personnel and property.
NOTE: In the event the unit is damaged, contact Industrial Motion Control’s
Wheeling factory or your local representative, for proper reconditioning or
repair (see sections 1.5 Requesting Service or 1.6 Returning a Unit for
Repair).
1.3. Operating Environment – This machine is intended to operate in a clean environment.
Excessive coolant, chips, dust dirt or debris can adversely affect its performance and life.
If this machine does operate in a dirty environment periodic cleaning must be practiced
and careful inspection of seals and accessories is necessary.
1.3.1. For extended storage, remove vents and fill with proper oil. (Refer to section 6)
1.4. Ordering Replacement Parts – When ordering parts, always provide the following
information:
1.4.1. The serial number shown on the nameplate.
1.4.2. The part name and/or the description listed in the manual.
1.4.3. The part numbers shown on the bill of material or assembly drawings.