DE-STA-CO P1700 - Manual (Page 22)

20
SECTION 8: Repair and Replace
8.1 Cam Follower Replacement - All Models
8.1.1. Drain oil & rotate the input shaft so that indexing cam is approximately in center of
dwell position. (See Figure 3)
8.1.2. Set unit on side opposite cap screw heads of screws holding the two housing
halves together.
8.1.3. Remove cap screws and tap top half of housing to break sealant loose and remove
top of housing.
8.1.4. Follow steps in Figure 7 to remove cam followers from hub assembly.
8.1.5. After changing cam follower set, remove all sealant from housing halves.
8.1.6. Apply new silicone rubber sealant bead up to the seals and assemble two housing
halves with cap screws removed in 8.1.3.
8.1.7. Tighten all screws evenly.
8.1.8. Refill with oil to level indicated.