Carlon Bore-Gard Florence - Manual

Bore-Gard
®
Installation - 100 ft.
Florence, SC
Distance of Installation: 100 feet
Maximum Pulling Force on Pipe: Estimated 800 pounds
Reamer Diameter: 6 inch
Soil Conditions: Sandy
This was a short bore in sandy soil conditions. Done beneath an active 3-lane street,
it proved how convenient the short lengths of Bore-Gard
are to transport and
assemble. Twenty foot lengths were installed for this major telephone company. The
top executive and many other managers were on hand to see first hand how cost
effective and tough Bore-Gard really is.
Above Left: Bore-Gard PVC pipe at a depth of 6 feet is being pulled beneath the active roadway.
The tight transition and resultant bend radius was no problem for the strong joint design. Above
Right: The entire Telco company crew was impressed with the simplicity, fast assembly, and
strength of Bore-Gard. The entire 100 feet of pipe was laid out in a few minutes for before the
installation.
Above Left: In the foreground is the drill entrance
location of the straight bore under the street for a total of 100 feet. Above Right: A close-up look at
the pulling eye (left), swivels, on-board computer and 6 inch reamer (right) attached to the lead end
of the Bore-Gard pipe (left) as it enters the ground.
Gross Automation (877) 268-3700 · www.carlonsales.com · [email protected]