B&K Precision 4013B - Manual - Manual (Page 15)

15
Use this knob to increase and decrease numeric values. The cursor indicates the low-order
position of the displayed value which changes when you rotate the knob (for straight numeric
entries only). For other types of data, the whole value changes when you rotate the knob.
3.10 Power-On Settings
Table 3-2 lists the factory default settings or selected after RECALL 0.
Table 1 – Power-on Default Settings
Key Function Value Description
Function Sine Output Waveform
Frequency 1.0000 kHz Waveform Frequency
Amplitude 5.00 V Peak-to-peak output amplitude
Offset 0.00 V Zero DC offset
Output OFF Output disabled
Sweep OFF Sweep function disabled
3.11 Memory
The waveform generator uses non-volatile flash memory for storing the front panel settings.
Up to 9 front panel settings can be stored (not including default settings).
3.12 Displaying Errors
The waveform generator displays error messages when front-panel settings are either invalid
or may produce unexpected results.
Table 2 – Error Messages
Message Text Description
Out of range The set value is out of the instrument’s limits
Setting Conflict Settings conflict with another parameter setting or value.
Empty location Attempt to recall settings from an empty storage location.
3.13 Quick Start
This section explains how to generate various waveforms and modify the output waveform.
* Generating a waveform output
* Modifying waveform output
* Storing and recalling a waveform generator setup