Atec Tektronix-DDS200 - Manual (Page 4)

Appendix A: Specifications
A–4 DDS200 Digital Demodulation System User Manual
Table A–2: Certifications and compliances
EC Declaration of Conformity –
EMC Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 55011 Class A Radiated and Conducted Emissions
EN 55011 Class B Radiated and Conducted Emissions
EN 50081-1 Emissions:
EN 55022 Class B Radiated and Conducted Emissions
EN 60555-2 AC Power Line Harmonic Emissions
EN 50082-1 Immunity:
IEC 801-2 Electrostatic Discharge Immunity
IEC 801-3 RF Electromagnetic Field Immunity
IEC 801-4 Electrical Fast Transient/Burst Immunity
IEC 801-5 Power Line Surge Immunity
EMC Compliance Meets the intent of Directive 89/336/EEC—Amended by 91/263/EEC, 92/31/EEC, 93/68/EEC— for
Electromagnetic Compatibility when it is used with the product(s) stated in the specifications table.
Refer to the EMC specification published for the stated products. May not meet the intent of the
Directive if used with other products.
FCC Compliance Emissions comply with FCC Code of Federal Regulations 47, Part 15, Subpart B, Class A Limits
EC Declaration of Conformity –
Low Voltage Compliance was demonstrated to the following specification as listed in the Official Journal of the
European Communities:
Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC
EN 61010-1:1993 Safety requirements for electrical equipment for measurement,
control, and laboratory use
Approvals UL3111-1 – Standard for electrical measuring and test equipment
CAN/CSA C22.2 No. 1010.1 – Safety requirements for electrical equipment for measurement,
control and laboratory use
Installation Category Descriptions Terminals on this product may have different installation category designations. The installation
categories are:
CAT III Distribution-level mains (usually permanently connected). Equipment at this level is
typically in a fixed industrial location
CAT II Local-level mains (wall sockets). Equipment at this level includes appliances, portable
tools, and similar products. Equipment is usually cord-connected
CAT I Secondary (signal level) or battery operated circuits of electronic equipment