Atec Tektronix_AFG3000_Series_Arbitrary-Function_Generators - Manual (Page 3)

Arbitrary/Function Generators — AFG 3011 / 3021B / 3022B / 3101 / 3102 / 3251 / 3252
Characteristic AFG3011 AFG3021B
AFG3022B AFG3101
AFG3102 AFG3251
AFG3252
Other Waveforms 1 µHz to 100 kHz 1 µHz to 250 kHz 1 µHz to 1 MHz 1 µHz to 2.4 MHz
Noise Bandwidth (-3 dB) 10 MHz 25 MHz 100 MHz 240 MHz
Noise type White Gaussian
DC (into 50 Ω) -10 V to +10 V -5 V to +5 V -5 V to +5 V -2.5 V to +2.5 V
Arbitrary Waveforms 1 mHz to 5 MHz 1 mHz to 12.5 MHz 1 mHz to 50 MHz 1 mHz to 120 MHz
Arbitrary waveforms in Burst
Mode
1 mHz to 2.5 MHz 1 mHz to 6.25 MHz 1 mHz to 25 MHz 1 mHz to 60 MHz
Effective analog
bandwidth (-3 dB)
8 MHz 34 MHz 100 MHz 225 MHz
Nonvolatile memory 4 waveforms 4 waveforms 4 waveforms 4 waveforms
Memory: Sample rate 2 to 128 K: 250 MS/s 2 to 128 K: 250 MS/s >16 K to 128 K: 250 MS/s
2 to 16 K: 1 GS/s
>16 K to 128 K: 250 MS/s
2 to 16 K: 2 GS/s
Vertical resolution 14 bits 14 bits 14 bits 14 bits
Rise/Fall time ≤80 ns ≤20 ns ≤8 ns ≤3 ns
Jitter (RMS) 4 ns 4 ns 1 ns at 1 GS/s
4 ns at 250 MS/s
500 ps at 2 GS/s
4 ns at 250 MS/s
Amplitude, 50 Ω Load 20 mV
p-p
to 20 V
p-p
10 mV
p-p
to 10 V
p-p
20 mV
p-p
to 10 V
p-p
≤200 MHz: 50 mV
p-p
to 5 V
p-p
>200 MHz: 50 mV
p-p
to 4 V
p-p
Amplitude, Open Circuit 40 mV
p-p
to 40 V
p-p
20 mV
p-p
to 20 V
p-p
40 mV
p-p
to 20 V
p-p
≤200 MHz: 100 mV
p-p
to 10 V
p-p
>200 MHz: 100 mV
p-p
to 8 V
p-p
Accuracy ±(2% of setting +2 mV)
(1 kHz sine wave, 0 V offset,
>20 mV
p-p
amplitude)
±(1% of setting +1 mV) (1 kHz sine wave, 0 V offset, >10 mV
p-p
amplitude)
Resolution 0.1 mV
p-p
, 0.1 mV
RMS
, 1 mV, 0.1 dBm or 4 digits
Units V
p-p
, V
RMS
, dBm (sine wave only)
Output impedance 50 Ω
Load impedance setting Selectable: 50 Ω, 1Ω to 10.0 kΩ, High Z (Adjusts displayed amplitude according to selected load impedance)
Isolation 42 V
pk
maximum to earth
Short-circuit protection Signal outputs are robust against permanent shorts against floating ground
External voltage protection To protect signal outputs against external voltages use fuse adapter 013-0345-xx
DC offset range, 50 Ω load ±(10 V
pk
– Amplitude
pp
/2) ±(5 V
pk
– Amplitude
pp
/2) ±5 V
pk
DC ±2.5 V
pk
DC
DC offset range, open circuit ±(20 V
pk
– Amplitude
pp
/2) ±(10 V
pk
– Amplitude
pp
/2) ±10 V
pk
DC ±5 V
pk
DC
Accuracy ±(2% of |setting| + 10 mV + 1%
of amplitude (V
p-p
))
±(1% of |setting| + 5 mV + 0.5% of amplitude (V
p-p
))
Resolution 1 mV
Modulation
AM, FM, PM
Characteristic Description
Carrier Waveforms All, except Pulse, Noise, and DC
Source Internal/External
Internal Modulating
Waveform
Sine, square, ramp, noise, ARB
(AM: maximum waveform length 4,096;
FM/PM: maximum waveform length 2,048)
Internal Modulating
Frequency
2 mHz to 50.00 kHz
AM Modulation Depth 0.0% to +120.0%
Min FM Peak Deviation DC
Max FM Peak
Deviation
See chart, below
Modulation: Max FM Peak Deviation
Characteristic AFG3011 AFG3021B
AFG3022B AFG3101
AFG3102 AFG3251
AFG3252
Sine 5 MHz 12.5 MHz 50 MHz 120 MHz
Square 2.5 MHz 6.25 MHz 25 MHz 60 MHz
ARB 2.5 MHz 6.25 MHz 25 MHz 60 MHz
Others 50 kHz 125 kHz 500 kHz 1.2 MHz
PM Phase Deviation – 0.0° to +180.0°
www.tektronix.com 3