Atec Teseq-Schaffner-CBA1G-275 - Manual (Page 2)

A d v a n c e d Te s t S o l u t i o n s f o r E M C
80 mhz to 1 ghz 275 Watt
Class a BroadBand amplifier
CBa 1g-275
Technical specifications
Frequency range (instantaneous) 80 to 1000 MHz
Rated output power 275 W minimum (350 W typical 80 MHz to 400 MHz)
Output power at 1 dB gain compression 250 W minimum (300 W typical 80 MHz to 400 MHz)
Gain 56 dB
Third order intercept point (see note 1) 64 dBm
Gain variation with frequency ±3 dB
Harmonics at 250 W output Better than -20 dBc
Output impedance 50 Ohms
Stability Unconditional
Output VSWR tolerance (see note 2) Infinite any phase
Input VSWR 2:1
RF connector style Type N female
Dual safety interlock Two BNC female connectors S/C to mute
and O/C to mute
USB interface Optional
Supply voltage (single phase) 184 to 264 Vac
(Floating input allows operation across 2 phases)
Supply frequency range
45 to 63 Hz
Supply power <2 kVA (nominal 1.6 kVA)
Mains connector IEC320
Conducted and radiated emissions EN61326 Class A
Conducted and radiated immunity EN61326: 1997 Table 1
Mains harmonic currents EN61000-3-2
Voltage fluctuations and flicker EN61000-3-3
Safety EN61010-1
Case dimensions 19 inch, 6U case, 550 mm deep
Delivered ready for inclusion into a standard rack
Mass
25 kg
Operating temperature range 0 to 40°C
Options (select at time of ordering)
341-850
Rack mountable with front panel mounted input/output connectors
341-950 Rack mountable with rear panel mounted input/output connectors
Notes:
1. The third order intercept point is a nominal value, as its calculation depends upon the power level at
which distortion measurements are made.
2. Output VSWR tolerance is specified for excitation within the permitted levels and frequency range.
© March 2012 Teseq ®
Specifications subject to change without notice.
Teseq
® is an ISO-registered company. Its products
are designed and manufactured under the strict
quality and environmental requirements of the ISO
9001. This document has been carefully checked.
However, Teseq
® does not assume any liability for
errors or inaccuracies.
Teseq AG
Nordstrasse 11F 4542 Luterbach Switzerland
T + 41 32 681 40 40 F + 41 32 681 40 48
[email protected]
www.teseq.com
691-288A March 2012