Atec Teseq-ProfLine_2103 - Manual (Page 2)

A d v a n c e d Te s t S o l u t i o n s f o r E M C
Mains supply options ProfLine 2103-240
System contents NSG 1007-3-240 Power source
CCN 1000-1 1-phase coupling unit
DAQ card
Interface cable
WIN 2100 H&F test software
WIN 2110 PQT test software
Pre-confi gured PC
USB cable
Power source (for full specifi cation see separate datasheet)
Power output (AC mode)
3,000 VA
Voltage AC, two ranges 0-150 V and 0-300 V
Maximum current (low range) 22.2 Amps, 110 Amps peak repetitive
Maximum current (high range) 11.1 Amps, 96 Amps peak repetitive
Frequency range (AC mode) 16 Hz – 1000 Hz
Power output (DC mode) 2,100 watts
Voltage DC, two ranges 0-200 V and 0-400 V
Maximum current (low range) 15.6 Amps
Maximum current (high range) 7.8 Amps
Supply 1-phase, 240 Vac L-N, 50/60 Hz
Dimensions (HxWxD) 178 x 483 x 610 mm
Weight 28 kg
Coupling unit
Number of phases
1
Measurement channels 4
EUT connector: Front panel CEE 77
EUT connector: Rear panel Terminal block
Maximum voltage: Front panel 240 Vac
Maximum current: Front panel 16 Arms
Maximum voltage: Rear panel 300 Vac
Maximum current: Rear panel 40 Arms (200 A Pk for 10 ms)
Supply power: Voltage 115/230 Vac +/- 10%
Supply power: Current <0.5 A
Supply power: Frequency 50/60 Hz
Dimensions (HxWxD) 89 x 427 x 560 mm
Weight 5 kg
Technical information
3 KVA 1-PHASE HARMONICS AND FLICKER
MEASURING SYSTEM
PROFLINE 2103
© February 2011 Teseq ®
Specifications subject to change without notice.
Teseq
® is an ISO-registered company. Its products
are designed and manufactured under the strict
quality and environmental requirements of the ISO
9001. This document has been carefully checked.
However, Teseq
® does not assume any liability for
errors or inaccuracies.
Teseq AG
Nordstrasse 11F 4542 Luterbach Switzerland
T + 41 32 681 40 40 F + 41 32 681 40 48
[email protected]
www.teseq.com
691-267A February 2011