Atec Teseq-AES_5501 - Manual (Page 4)

AUTOMOTIVE EMISSIONS SYSTEM FOR ISO 7637-2
AES 5501
Switch housings are compact, optimized for comformity to strict layout requirements and
offer ample earth contacts.
125 mm
50
m
m
© February 2011 Teseq ®
Specifications subject to change without notice.
Teseq
® is an ISO-registered company. Its products
are designed and manufactured under the strict
quality and environmental requirements of the ISO
9001. This document has been carefully checked.
However, Teseq
® does not assume any liability for
errors or inaccuracies.
Teseq AG
Nordstrasse 11F 4542 Luterbach Switzerland
T + 41 32 681 40 40 F + 41 32 681 40 48
[email protected]
www.teseq.com
691-268B February 2011
1) Active, temperature dependant cooling. The ES 5501 is depending on duty cycle, approximately
3 minutes at 100 A with 100% duty cycle before the switch will be deactivated for cooling.
2) With supplied relay or electronic switch
3) With test load defi ned in ISO 7627-2. Purely resistive loads display typically in the range of a few
microseconds.
Accessories
Included: 4 x 60 mm cable, MC connector
Included: 2 x 100 mm cable, MC connector
Included: 4 x 0 mm pin, used when the housings will be pushed together (for zero millimeter distance)
Included: INA 5031 – 100:1 high voltage probe compliant to ISO 7637-2
Optional: INA 163 – Set of ten MC to banana adapters (only available in red)
Optional: INA 5500-TL – Reference load (R = 0.6 Ω, L = 50 µH)
Optional: INA 5500-CK – Calibration kit for impedance curve verifi cation (used for connection to
network analyzer)
Optional: MS 5501 – Additional unit for additional prepared relays
Optional: Various inserts for MC 5501 for industry standard relay footprints