Atec Teseq-AES_5501 - Manual (Page 3)

Teseq AG
Nordstrasse 11F 4542 Luterbach Switzerland
T + 41 32 681 40 40 F + 41 32 681 40 48
[email protected]
www.teseq.com
AUTOMOTIVE EMISSIONS SYSTEM FOR ISO 7637-2
AES 5501
691-268B February 2011
Technical specifications
Complete system 1)
Battery current 100 A
Inrush current 2) 300 A for 200 ms
Battery voltage 0 to 60 VDC
Shunt resistor (R
S
) 10, 20, 40, 120 Ω, Ext.
Trigger modes External, internal, manual
Battery off time (t
off
) 10 ms – 10 s ±(10% + 10 ms)
Battery on time (t
on
) 0.5 ms – 10.5 s ±(10% + 10 ms)
Mains input voltage 85 – 264 VAC, 47 – 63 Hz
Available relay voltage 12, 24, 36 V (for 42 V applications)
Electronic switch
Switching time Δt
S
300 ns ±20% 3)
Voltage drop <1 V @ 25 A
Typical 2.1 V @ 100 A
Transient voltage protection 440 V
Mechanical switch
Type
Automotive relay
Contacts High purity AgNi with no suppression across contacts
Voltage rating > 400 V
Artifi cial network
Inductance
5 µH
Capacitance 0.1 µF
Resistance 50 Ω
Impedance As per ISO 7637-2 (see above impedance curve)
Connectors 100 A MC type, countersunk, 50 mm above ground plane
Housing Stainless steel, unpainted underside, screw terminal and
earth connections
Indicators Counter on relay, LED indicator on controller for mechanical
and electronic switches
Measurements ports MS 5501, ES 5501 - directly connected to output
AN 5501 – 5.6 k output impedance (to output connector –
necessary for improved RF performance)
Physical dimensions (L x W x H) ES 5501 125 x 125 x 125 mm
MS 5501 125 x 125 x 125 mm
AN 5501 340 x 270 x 205 mm
All tolerances ± 10% unless otherwise noted.
© February 2011 Teseq ®
Specifications subject to change without notice.
Teseq
® is an ISO-registered company. Its products
are designed and manufactured under the strict
quality and environmental requirements of the ISO
9001. This document has been carefully checked.
However, Teseq
® does not assume any liability for
errors or inaccuracies.