Atec Yokogawa-DR232 - Manual (Page 3)

15
Contact capacity: 250 VDC/0.1 A (resistive load),30 VDC/2 A (resistive
load),250 VAC/2 A (resistive load)
● Remote Control Signal Input
Function: Start and stop recording
Change chart speed
Start message printing
Start and stop memory sampling
Control statistical calculation interval
Input signal: Non-voltage contact or open collector (TTL or
transistor)
Extension Modules
Unit to connect with:
DS400 or DS600 subunit (one for each subunit)
Number of input modules: One input module can be mounted on an extension base
unit. Up to 3 extension base units can be connected to one
extension module in series.
Types of input modules: 10-ch universal input module
10-ch DCV/TC/DI input module
Extensible distance: Up tp total length of 30 m
Communications Modules
Specifications Common to Communications Modules
● Functions, Common Specifications
Outline of functions: Output of measured values, output of set points,
setup of measurement conditions, control of start/
stop of measurement, etc.
Withstanding voltage: 1,500 VAC (50/60 Hz) for one minute between output
terminal and ground
GP-IB Modules
Electrical and mechanical specifications:Based on IEEE standard 488-1978
Addresses:
0 to 15
RS-232C Modules
Electrical and mechanical specifications: Based on EIA RS-232C
Communications format:
Half duplex
Synchronization: Start-stop synchronization (synchronization by
means of the start and stop bits)
Baud rate: 150, 300, 600, 1200, 2400, 4800, 9600, 19200 or 38400
bps
Transmission distance: Maximum of 15 m
Connector: D-sub 25-pin connector
RS-422A/485 Modules
Electrical and mechanical specifications:
Based on EIA RS-422A and EIA RS-485
Connection method: Multi-point
Address: 1 to 31
Communications format: Half-duplex, 4-wire method/2-wire method
Synchronization: Start-stop synchronization (synchronization by
means of start and stop bits)
Baud rate: 300, 600, 1200, 2400, 4800, 9600, 19200 or 38400 bps
Transmission distance: Maximum of 1200 m
Connector: 6-screw terminal
Ethernel Modules
Network configuration:
Ethernet (10Base-T)
10Base-T modular connector: 1
Baud rate: 10 Mbps
Communication protocol: TCP, UDP, IP, ARP or ICMP
Input data: ASCII
Output data: ASCII or binary
■ Model and Suffix Codes
DR230 Stand-alone model
DR231
Memory
Software
Input channel
Input
Power supply voltage
Power inlet, power cable
Additional specifications
Model Suffix code
-0
-1
0
2
-1
-2
-3
1
2
3
4
D
F
R
S
/M1
/M3
/C1
/C2
/C3S
/C7
/N7
/N8
/A4
/R1
/H1
/H5
/D2
/P6
Description
Desk-top type hybrid recorder
No memory
3.5-inch FD
No DAQ 32 software
DAQ 32 software included
10 ch
20 ch
30 ch
Universal input, screw
Universal input, clamp
DCV/TC/DI input screw
DCV/TC/DI input clamp
100 to 240 VAC
3-pin power inlet w/UL CSA cable
3-pin power inlet w/VDE cable
3-pin power inlet w/SAA cable
3-pin power inlet w/BS cable
Computing functions
Report function
GP-IB
RS-232C
RS-422/485 (screw)
Ethernet
Power monitor for single phase
Power monitor for 3 phase
Alarm output module (A type 10 contacts)
2-point alarm output, remote control signal input, fail output, and chart end output
Internal illumination
Carrying handle
° F display
DC power supply (AC and DC power supply coexist)
Must not coexist
Must not coexist
● The maximum allowable number for the / N , / C , / A4 and / R1 options is determined according
to the specified channel number.
10 ch: All options can be specified.
20 ch: All of them can be specified.
30 ch: 3 of them can be specified.
-1
DR230 Expandable model
DR232
Memory
Data conversion
Input
Power supply voltage
Power inlet, power cable
Additional specifications
Model Suffix codes
-0
-1
0
2
Description
Desk-top type hybrid recorder
No memory
3.5-inch FD
No DAQ 32 software
DAQ 32 software included
Always -00
100 to 240 VAC
3-pin power inlet w/UL CSA cable
3-pin power inlet w/VDE cable
3-pin power inlet w/SAA cable
3-pin power inlet w/BS cable
Computing function
Report function
Internal illumination
° F display
-1
D
F
R
S
/M1
/M3
/H1
/D2
●
●
Subunits and input/output modules must be ordered separately from the main unit.
The extersion cable must be ordered separately when the subunit is specified.
-00
Subunit: DS400, DS600
Model Suffix codes
DS400
DS600
Type
Power supply voltage
Power inlet, power cable
-00
-1
D
F
R
S
W
Description
4-module connection type subunit
6-module connection type subunit
Always -00
100 to 240 VAC
3-pin power inlet w/UL CSA cable
3-pin power inlet w/VDE cable
3-pin power inlet w/SAA cable
3-pin power inlet w/BS cable
With 3-pin inlet screw conversion terminal
Configuration example of the expandable model
● 100 ch, 0.5 s universal input, with RS-232C and 20-ch alarm output
• DR230 expandable main-unit: DR232
× 1
• Sub unit: DS600 × 2
• Universal input module: DU100-11 or -12 × 10
• Communication module: DT300-21 (RS-232C) × 1
• Alarm output module: DT200-21 × 2
• Extension cable Ч 2