Atec MCL-MT4100 Series - Manual (Page 3)

INC INC
A MITEQ COMPANY
C O N T R O L A N D S TAT U S C A PA B I L I T I E S
TYPE FUNCTION
Filament ON/OFF Units Select Fault Counter ON/OFF
Transmit/Standby *Hold Power ON/OFF Antenna Position (1:1)
Controls *RF ON/OFF Auto Switching (1:1) Load Position (1:1)
Reset Manual Switching (1:1) Local/Remote/Computer
*Attenuation
*Auto Power RF Reflected Power Alarm RF Reflected Power Fault
Tube Temperature Alarm RF High Alarm Filament Under Current Fault
Adjustable Parameters RF Low Alarm Comm Band Rate Comm Protocol
Comm Address Time
Date
RF Forward Power Helix Current RF Reflected Power
Displays Helix Voltage Tube Temperature Filament Current
Filament Delay PS Temperature
Tube Temperature Switch WG Pressure PS Temperature
Faults Tube Temperature Analog Helix Surge Current Chassis Interlock
(Notification, Helix Run Current HV Over Voltage Filament Under Current
RF & HV Shutdown) HV Under Voltage
User Interlock
RF High RF Low PS Temperature
Alarms RF Reflected Tube Temperature RF Switch Failed
(Notification Only) Blower Failed AC Low Line
Exciter
Delay Transmit Selected Sampler Port Cal Table
Summary Alarm Summary Fault RF Low Switching ON/OFF
Additional Status Computer Tx Computer Rx Remote Tx
Remote Rx Event Log Fault Log
Maintenance Log
* Optional
ENVIRONMENTAL
SPECIFICATIONS
Operating Temperature:
-1 0°C to +40°C
Non-Operating Temperature:
-4 0°C to +70°C
Relative Humidity:
95%, non-condensing
Operating Altitude:
10,000 ft. above sea level (3,048 m)
with standard adiabatic derating
Non-Operating Altitude:
50,000 ft. above sea level (15,240 m)
Vibration:
Method 514-4 of
MIL-STD-810E Procedure I, Figures 514.4-1,
514.4-2, 514.4-3
Shock:
10 g, 11ms
MECHANICAL
SPECIFICATIONS
RF Connectors:
Input: Type SMA female
Output: 2.0–8.0 GHz SC (Male)
6.0 – 18.0 WRD-650
7.5 – 18.0 WRD-750
Installed Weight:
Figure 2: 65 lbs.
Figure 1: 90 lbs.
Cooling:
Closed Loop Circuit