Atec Marine-Magnetics-SeaSpy - Manual (Page 2)

Save Hours of Frustration
A quick glance self diagnostic
LED sytem, on our isolation
transceiver, has saved our cus-
tomers hours of frustration.
A
green light = all connections are hooked
up properly
A
yellow light = a problem with one of
the connections
A
red light = a short. Within micro seconds,
the transceiver will safely shut down the
output power
A
blue LED flashes with every mag reading
Protecting Your Assests
A warning sounds when even a drop of wa-
ter gets inside the mag, giving the operator
plenty of time retrieve it, and investigate the
cause, before the mag is damaged. For an-
other level of security, should water get into
the mag, the electronics are enclosed in an
o’ring sealed polycarbonate housing.
Overhauser Effect
SeaSPY is a pulsed Overhauser magnetom-
eter that measures the ambient magnetic
field using a specialized branch of nuclear
Magnetic Resonance technology, applied
specifically to hydrogen nuclei.
See our Technical Application Guide for more
information about your technology.
World Wide Operation
with No Restrictions
SeaSPY will collect accurate
data no matter where you are or
in which direction you are sur-
veying. This is not the case with
optically pumped magnetometers which
have dead zones and must be oriented at a
specific angle relative to the earth’s magnetic
field. This issue can be particularly problem-
atic in equatorial regions where you cannot
collect data in every direction.
Eliminate Shifts In Your Data
‘Heading error’ is a noticeable offset in the
magnetometer output caused by changing
the heading of the magnetometer within the
Earth’s magnetic field. Since SeaSPY’s Over-
hauser technology does not display heading
error, no matter how the sensor is oriented in
the Earth’s magnetic field, successive survey
lines taken in opposite directions will match
up perfectly.
The benefits to the user are:
1. Targets will not be missed because they
fall between mismatched survey lines.
2. A magnetic map of an area will look
the same, regardless of the direction in
which the survey lines were conducted.
Works Instantly On Power-Up
SeaSPY works equally well in
cold, deep waters as tropi-
cal waters, starting instantly
on power-up without requir-
ing warm up. Data collected at –40°C will
be identical to data recorded at +60°C.
Maintenance Free Sensors
SeaSPY sensors don’t de-
grade with time, so you’ll get
the same quality data after
10 years of use as you did the first time you
used it.
In addition SeaSPY sensors contain no con-
sumable parts, so you won’t have to replace
anything, like the expensive lamps that wear
out in optically pumped mags.
Proven Sensitivity Specs
Don’t just take our word for
it. We put our sensors under
scrutiny, through rigorous in-
dependent testing by a world
authority belonging to INTERMAGNET. In-
termagnet is the global network of observa-
tories, monitoring the Earth’s magnetic field.
Tests confirm our specifications.
Highest Absolute Accuracy
If you want good data you
have to start with the most
accurate sensor.
SeaSPY sensors are orders
of magnitude more accurate
than any other magnetometer: 0.1nT ensur-
ing that you are always getting the best pos-
sible data.
R
eliability
Bett
er Da
ta