Atec HiloTester-CE-Tester - Manual (Page 3)

Technical specifications subject to change, CE_TESTE_3G.DOC, 10/12 Page 3/3
HILO-TEST GmbH, Am Hasenbiel 42, D-76297 Stutensee-Karlsruhe, Tel. 07244/20500-0, www.hilo-test.de
TECHNICAL SPECIFICATIONS CE-TESTER
Mainframe
Microprocessor controlled touch panel 5”, 800X480, 24 bit
Optical Ethernet Interface for remote control of the generator optional
Interface for saving reports USB
External trigger input /output 10 V at 1 kΩ
Coupling-/decoupling network for power supply lines L1, N, PE
Nominal voltage, nominal current 250 V, 16 A ≈ / 10 A =
Coupling impedance (depending on the generator) 33 nF / 18 µF / 9µF+10Ω
Connector for external safety interlock loop 24 V =
External red and green warning lamps 230 V, 60W
Mains power 230 V, 50/60 Hz
Dimensions of desk top case W * H * D 450*185*500 mm
3
Weight 25 kg
BURST acc. to IEC 61000-4-4: 2011
Pulse output voltage, adjustable 0.2 - 5.0 KV ± 10 %
Waveform 5/50 ns
Source impedance 50 Ω
Polarity, selectable pos/neg/alt
Burst frequency, adjustable 1.0 kHz - 1.0 MHz
Burst duration, adjustable 0,01 ms - 25 ms
Burst repetition rate, adjustable 10 ms - 1000 ms
HV output for external coupling devices coaxial
Monitor output for pulse output voltage ratio = 100:1 ± 5%, 50 Ω
SURGE acc. to IEC 61000-4-5: 2007
Test voltage (open circuit condition) 0.2 – 5.0 kV ± 10 %
Waveform acc. to IEC 60060 1.2 / 50 µs ± 20 %
Test current (short circuit condition) 0.1 - 2.25 kA ± 10 %
Waveform acc. to IEC 60060 8 / 20 µs ± 20%
Polarity of output voltage/current, selectable pos/neg/alt
Maximum stored energy 120 Joule
Charging time for max. charging voltage < 10 s
HV output isolated from ground HV-OUT, 4mm
Mains synchronous triggering, phase shifting, digitally selectable 0 - 359°, step 1°
Monitor output for pulse output voltage ratio = 1000 : 1 ± 5%
Monitor output for pulse output current 10 V ≡ 5 kA ± 5%
Option: Software CE-REMOTE Test, for remote control
With Impulse Recording Function (IRF)
( XP, WIN7 ) incl. 5 m fibre optic cable and PC Ethernet interface
POWER FAIL acc. to IEC 61000-4-11: 2004
Rated current / Inrush current, max. 16 A / 500A
Monitor output for mains voltage and mains current built-in
Display of mains voltage, mains current and inrush current
Interface for control of an external power source
Option: External power source VPS 250-16
Output voltage, adjustable 0 - 250 V
Rated current 16 A
Control via interface of CE-TESTER
Option: Induction Coil HI 100 acc. to IEC 61000-4-8/9: 2010/2001
Dimensions 1000*1000*600 mm
3
Coil factor 1.0 ± 10%