Atec Haefely-PSURGE8000 User Manual
Page 4
Headquarters
Haefely Test AG
Lehenmattstrasse 353
CH-4052, Basel
Switzerland
+ 41 61 373 41 11
+ 41 61 373 45 99
Locate your local
sales representative at
www.haefelyEMC.com
North American Office
Hipotronics Inc.
Haefely EMC Division
1650 Route 22
Brewster, NY 10509
++1 845 279 3644 x264
++1 845 279 2467
Haefely has a policy of continuous product improvement. Therefore we reserve the right to change design and specification without notice.
PSURGE8000_concept_overview_2006-05-18.doc
Interfacing
RS232 / IEEE
In addition to front panel control, a system can be
controlled from the WinFEAT&R software package.
Both RS232 and IEEE interfaces are supported.
EUT fail input
Connect pass/fail detection hardware to this BNC
input and the EUT condition, as determined by
specific EUT supervision hardware, is added to the
database of test information and finally the log file.
EUT condition can also be used to determine the test
course.
Start / Stop
This feature can be used to create a semi-automatic
test environment where multiple samples must be
tested using the same routines. A test cabinet cover
or other safety device connected to the Start/Stop
input is used to start or stop the same test routine.
When the safety device is open, the test system is
rendered safe and test samples can be exchanged.
Close and the system pulses.
Synchronisation input
Impulses can be synchronised to any external cyclic
signal with a high degree of accuracy.
Trigger Input
External signals can be used to trigger impulse
generation to a particular event.
Trigger Output
BNC socket to trigger an oscilloscope or other
device coincident with the impulse. The trigger
signal is a negative edge transition. Level +5Vdc
PLUG & PLAY to accurate SURGE IMPULSES
DRAG & DROP to easy CONTROL and REPORTING
WinFEAT&R
WinFEAT&R is a completely new from the ground up
software package that is designed from the outset to
run under Win 9x, WinNT and XP operating systems.
Haefely EFT, LINE and SURGE platform systems are
all integrated for fully automatic control of a complete
test suite.
WinFEAT&R is the product of market feedback and
experience gained over many years in the EMC
testing world. The acronym stands for
F
ast
E
asy
A
ccurate
T
esting &
R
eporting, in WinFEAT&R we
have achieved all these things.
Particular care was taken in designing the GUI
(Graphical User Interface), which incorporates many
new and innovative features aimed at simplifying user
interactions. Drag and drop techniques combined
with on screen graphics make WinFEAT&R truly
intuitive.
System configuration is an extension of the plug &
play philosophy. Hardware attached to the system
bus is auto-detected. Individual test instrument
specifications are displayed and made available.
Individual test and program execution times are
displayed giving a detailed preview of the complete
process.