Atec keytek-mz30 - Manual (Page 3)

Optional Components
Optional parts for ISO 10605 standard test
These are option parts for the ISO 10605 standard test. CR unit and discharge tip are
available.
Product name Model name
CR Unit (330pF/3301) for ISO 10605 CR22
CR Unit (150pF/3301) for ISO 10605 CR23
Air discharge tip for ISO 10605 AT22
Contact discharge tip for ISO 10605 CT22
CR22 CR23 AT22 CT22
C Unit Discharge Resistor*
IEC61000-4-2 specifies the combination of the energy storage capacitor and the discharge
resistor. Different combinations of the C unit and the discharge resistor can simulate various
conditions.
* Some versions of the energy storage capacitor and the discharge resistor may shorten the
life of the discharge-generating high-voltage switch in the discharge gun.
Capacity Model name
150pF EC21
100pF EC22
200pF EC23
250pF EC24
300pF EC25
330pF EC26
400pF EC27
500pF EC28
C Unit
This unit is inserted into a discharge gun. It consists only of an energy storing capacitor.
A separately sold discharge resistor must be connected to it during use.
Discharge Resistor
Equipped inside the option C unit to limit discharge current.
Discharge Gun Stand
This is the stand used to fix the discharge gun. it is convenient to discharge electricity at
the same point; the vertical joint plate in particular.
Resistance value Model name
3301 DR21
1001 DR22
1501 DR23
2001 DR24
3001 DR25
4001 DR26
5001 DR27
1k1 DR28
1.5k1 DR29
2k1 DR30
5k1 DR31
10k1 DR32
101 DR33
Product name Model name
Discharge gun stand GS21
Testing Environment Fixtures
IEC61000-4-2 specifies the testing environment based on equipment type. The following
equipment is required to conduct an ESD immunity test meeting the EUT requirements.
Accessories
Product name
CTC-3
Coaxial current monitor target per
IEC61000-4-2
HCP-1 Horizontal Coupling Plane (HCP)
TP-3 Full 1.5m x 1.5m IEC1000-4-2 Target Plane