Atec PMM-L2-16B - Manual

L2-16B
Two Lines Single Phase V-Network
9 kHz - 30 MHz, 16 A for AC and DC powered EUT
The AMN - Artificial Mains Network, also known as LISN - Line Impedance Stabilization
Network - is the ancilliary device intended for repeatable and accurate measurement of
the disturbance voltage that an EUT (Equipment Under Test) may inject into the power
line or mains.
This is obtained by providing well known impedance value and phase response across
the frequency range of the test.
PMM L2-16B is suitable for measurement on AC single phase and DC power circuits from
DC to 60 Hz. The equivalent V-Network circuit of 50 Ω // (5 Ω + 50 μH) with 250μH choke
is fully compliant with the reference standards .
PMM Artificial Mains Networks provide robust and stable mechanical construction, high
quality electric components, easy and perfect grounding, solid input-output power con-
nections. They can be used in conjunction with any EMI receiver or spectrum analyzer and
offer features required for safe, repeatable and accurate measurements.
Provided Features
• Powering the EUT
• EUT termination to a standardized
impedance respect to the reference ground
• Coupling of the measuring receiver to the
disturbance generated by the EUT
• Decoupling of the measuring receiver from
unwanted RF signals from the power line
Main Features
• 9 kHz to 30 MHz frequency range
• Up to 16A continuous rated output current
• Suitable for DC to 60 Hz power lines
• Built-in, selectable 150 kHz high pass filter
• Artificial Hand circuit
• Local and remote control from PMM EMI
receivers
• Meets the requirements of several standards
including CISPR 16-1-2, VDE 0876, FCC part
15, MIL-STD 461F